Synthesizer Printed Circuit Boards
TH-101 “Sheboygan” 566-based Voltage-Controlled Oscillator
TH-101 Sheboygan PCB artwork (top)
Meet the Sheboygan!
Designed by famous do-it-yourself synthesizer guru Thomas Henry, the TH-101 is a voltage-controlled oscillator (VCO) based on a nearly forgotten integrated circuit: it is a 1V/octave response VCO built around the 566 VCO chip.
A companion to Thomas Henry?s
Making Music with the 566 VCO
book, this PCB has all the waveshapers from the book and has the following features:
Note: The only departure from the 566 book is in the Saw waveshaper. The sawtooth shaper shown in the 566 book is interesting but changes the frequency of the output. You also lose the Tri and Sine outputs with that circuit. Because of these reasons, we instead adapted the tri-to-saw circuit used on the LM VCO in Thomas' “An Analog Synthesizer for the 21st Century.” This waveshaper works much better, and is easy to trim for proper operation.
If you want quadrature square waves, use the Square out and the Pulse output (Pulse Width set to 50%). Of course, setting the pulse width to something other than 50% allows you to change the phase relationship between the square and the pulse (might sound neat for clocking two sequencers, or two sample & hold units, or ???).
The PCB is available for do-it-yourselfers. It is not difficult to build compared to other synthesizer modules, but Magic Smoke does not recommend this for your first DIY experience.
Subscribe to Smoke Signals and we’ll keep you posted. We will not share, give, sell, fold, spindle, or mutilate your e-mail address.
Specifications and prices are subject to change.
© 2006-2014 Magic Smoke Electronics